Electronics Design
This was the first time I dis actual work in electronics design; especially in Eagle.
It took some time to get used to and I made a lot of mistakes, mainly because I didn't take my time and read the tutorials.
Here are a photos of before and after :D
Schematic Design
Started by placing some components
Creating some nets and labeling them
Finishing up connecting and repositioning components
Switching to board view
Positioning components and creating routes
DRC checking and fixing errors
Adding a button and a LED
Exporting the board image
After hiding all unnecessary layers, I exported the image.
And the following are the traces and the interiors of the board
Then used Fabmodules using the default values
And here is a photo of the board after soldering and connecting to the programming
