<<<< go back
The initial project proposal.
Drawing and sketching details from Beesbot
Designing and making details for Beesbot.
Producing a programmer that was used to program all other Fabkit that were made.
3D-printing a complex shaped bottle and a mould to cast the bottle in beeswax
Make a big H-bot frame (it was too big).
Reading data through the serial data connection.
Gripper to take out frames from the Beesbot.
Run a stepper motor on self made pcb's.
Stabilising part for bee frames.
Make network from Fabkits by using I2C
Test graphical interface for end switches from Beesbot.
Wake up call for making the project.
Licensing the project and its future.
Any content on these pages by Paul Gröneveld
is licensed under a Creative Commons Attribution-NonCommercial-ShareAlike 4.0 International License
Here you can download the complete assembly from the Beesbot in Solidworks.
Directly from this site: Download file