• 01. 3D Scanning
• 02. 3D Printing

3D Scanning

---

3D Printing

I used tinkercad to design my 3d model. Following is my step.

1. I created a cube.

2. I created a sphere whose diameter is slightly bigger than cube's length.

3. I put the sphere into the cube.

4. I maked the sphere become hollow.

5. I grouped the cube and sphere.

6. The cube become hollow.

7. I put a sphere whose diameter is smaller than cube's length into cube.

I printed it in the lab by using Ultimaker.

I put it into water.

Final result:

ball.stl

---