Design of object

neil told in his lecture that make somthing big so i think on that what to do.then i saw one foldeble laptop table.but it is small and it is alrady available in market.then i think about my solar panel dish but last time supriya already done the panel dish,then panel stand i was decide but yet my plan is not ready of project so this is also i cancled and in one day i was in my lecture hall and i saw that our podium is not in good condition so i will decide that make podium for vigyan asharam.


I decide to make the podium for vigyan asharam

I draw podium design on paper i gave it some dimentions.there are 6 parts in my design base,top,side1,side2,mid1,mid2 etc.according with design i gave the dimentions.


this is whole design of podium on paper


then i open the solid works and start to design.then i will make base first for that i select the rectangle command and i gave the smart dimention to it.width=750mm,breadth=500mm,height=12mm.my base of podium is now ready.


then i again open the solid works and start to design.then i will make base first for that i select the rectangle command and i gave the smart dimention to it.width=680mm,breadth=500mm,height=12mm.my base of podium is now ready.


For design the side i go to the line command i gave the arc to the straight line then it becomes curvethen i extrude that part then on its surface i use draw the cuircl and i cut it.height=1160mm


For design the side i go to the line command i gave the arc to the straight line then it becomes curvethen i extrude that part then on its surface i use draw the cuircl and i cut it.height=1160


then i make middle part for that i make a notch and i take rectangle and i extrude that part.


then i make middle part for that i make a notch and i take rectangle and i extrude that part.


this is my podium design now i want to cut this design on shopbot.


Learning outcomes

In this session i handle the solid works software and in that i made asssemble when i make assemble my design look nice and i learn how the design made with concentarated wt.and how make the assembly.

lets move towards software setting of shopbot