This task meant a lot to me because it helped me to explore and learn in more detail the inventor software which I believe I'm dominating. The first question I asked myself was what should I cut? and it occurred to me to design a prototype aircraft. In attached picture I show when I started designing my prototype.
After it became clear the idea of my prototype I started drawing with Rhinocero 5.0 which I believe is not to my liking because it has certain limitations as to the dimensions. I'm not saying that the software will be bad but my need is not adjusted properly so I had some drawbacks to draw and then assemble as I show in the following photographs.
I made the first impression but it was not as it should ...
Then I could see that I made some mistakes such as not being able to give the proper dimensions is why when I did not fit assembling aircraft parts as you can see.
It was then I decided to use my prototype inventor since I recommended using it because it is a software where you can assign dimensions and thus ensure that the assembly is correct. I show you some pictures of the design with Inventor.
The conclusion of this task I have is that I learned to use several software design can now differentiate and know use them according to the needs you have. From my point of view I think that is a very interesting Inventor software because you can assign dimensions, assemblies, etc. modelamientos which helps you to illustrate your work much as if you had in reality. Obviously it helps you avoid errors and simplify waste as doing a pre assembly on the computer can correct the mistakes that have been presented.
Thank you.