<b>CAPACITOR</b>
>NAME
>VALUE
<b>SMALL OUTLINE DIODE</b>
>NAME
>VALUE
>NAME
>VALUE
<b>Male(J), Female(P) and Pin Headers</b><p>Version 1.02 - 03/10/2009<p>
This library is a collection of various pin headers and AMP, Molex and 3M board-to-board connectors.
This library assumes the notion of JACKS(male) and PLUGS(female) as represented by the J and P symbols.
Standard male/female pin header types are available in common 0.1" and 2 mm pitch types with alternate mirrored footprints as well.
<p>THIS LIBRARY IS PROVIDED AS IS AND WITHOUT WARRANTY OF ANY KIND, EXPRESSED OR IMPLIED.<br>
USE AT YOUR OWN RISK!<p>
<author>Copyright (C) 2008, Bob Starr<br> http://www.bobstarr.net<br></author>
<b>SIP Header</b> - 0.1", 32 mil drill
>NAME
>VALUE
<b>SIP Header</b> - 0.1", 32 mil drill
>NAME
>VALUE
*
*
>NAME
>VALUE
<b>RESISTOR</b><p>
chip
>NAME
>VALUE
<b>CAPACITOR</b><p>
grid 5 mm, outline 2.5 x 7.5 mm
>NAME
>VALUE
<b>RESISTOR</b><p>
chip
<b>CAPACITOR</b><p>
grid 5 mm, outline 2.5 x 7.5 mm
<b>Single Pads</b><p>
<author>Created by librarian@cadsoft.de</author>
<b>THROUGH-HOLE PAD</b>
>NAME
>VALUE
THROUGH-HOLE PAD
<b>PIN HEADER</b>
>NAME
>VALUE
<b>Jumpers</b><p>
<author>Created by librarian@cadsoft.de</author>
<b>JUMPER</b>
>NAME
>VALUE
JUMPER
<b>EAGLE Design Rules</b>
<p>
Die Standard-Design-Rules sind so gewählt, dass sie für
die meisten Anwendungen passen. Sollte ihre Platine
besondere Anforderungen haben, treffen Sie die erforderlichen
Einstellungen hier und speichern die Design Rules unter
einem neuen Namen ab.
<b>EAGLE Design Rules</b>
<p>
The default Design Rules have been set to cover
a wide range of applications. Your particular design
may have different requirements, so please make the
necessary adjustments and save your customized
design rules under a new name.
Since Version 8.2, EAGLE supports online libraries. The ids
of those online libraries will not be understood (or retained)
with this version.
Since Version 8.3, EAGLE supports URNs for individual library
assets (packages, symbols, and devices). The URNs of those assets
will not be understood (or retained) with this version.
Since Version 8.3, EAGLE supports the association of 3D packages
with devices in libraries, schematics, and board files. Those 3D
packages will not be understood (or retained) with this version.