/////// note make a photo of all the printers and scan machines in fablab promo FabAcademy week_05
3D printing and 3D scanning

week_05

assignment

_* test the design rules for your printer(s) (group project) * design and 3D print an object (small, few cm) that could not be made subtractively * 3D scan an object (and optionally print it) (extra credit: make your own scanner)_

keywords

_David Andy Valentin Zaerc hello.ISP.44.cad board components traces interior hello.ISP.44.res.cad board traces interior inventory microcontroller crystal USB connector ribbon connector Zener diode jumper firmware.zip USB power make clean make hex (sudo) make fuse (check programmer in Makefile, may need to repeat) (sudo) make program desolder SJ1 and SJ2 make IDC ISP cable, connecting header pin 1 to pin 1, check wires_

useful links

FabAcademy 2016_schedule

FabAcademy 2016 lecture_upload the right link for neils lecture

FabAcademy 2016 recitaiion_On creating a new economy and using the human power for a better future_

Vinay Gupta_presentation slides

photogrammetry_comparison of different phptpgrammetry SW

experimentation

make it happen

01_object to scan - dragonfly

inkscape

02_photogrammetry_free SW Autodesk MEMENTO for creating 3d mesh from photos

inkscape inkscape inkscape

03_Modela scanning

inkscape

03_Blender 3d scan mesh repair before printing

inkscape inkscape

05_3d printing with different filaments

///test with filaflex / settings temperature-230/bed temperature-50/ print speed 50