/*
Turns ON an RGB LED on for two second
*/

// the setup function runs once when you press reset or power the board
void setup() {
// initialize digital pin 5,6 & 7 as an output.
pinMode(PB0, OUTPUT);
pinMode(PB1, OUTPUT);
pinMode(PB2, OUTPUT);

}
// the loop function runs over and over again forever
void loop() {
  digitalWrite(PB0, HIGH);  // green
  digitalWrite(PB1, LOW);  // red
  digitalWrite(PB2, LOW);  // blue
  delay(200);
  digitalWrite(PB0, LOW);  // green
  digitalWrite(PB1, HIGH);  // red
  digitalWrite(PB2, LOW);  // blue
  delay(200);
  digitalWrite(PB0, LOW);  // green
  digitalWrite(PB1, LOW);  // red
  digitalWrite(PB2, HIGH);  // blue
  delay(200);
  digitalWrite(PB0, HIGH);  // green
  digitalWrite(PB1, HIGH);  // red
  digitalWrite(PB2, LOW);  // blue
  delay(200);
  digitalWrite(PB0, LOW);  // green
  digitalWrite(PB1, HIGH);  // red
  digitalWrite(PB2, HIGH);  // blue
  delay(200);
  digitalWrite(PB0, HIGH);  // green
  digitalWrite(PB1, LOW);  // red
  digitalWrite(PB2, HIGH);  // blue
  delay(200);
  digitalWrite(PB0, HIGH);  // green
  digitalWrite(PB1, HIGH);  // red
  digitalWrite(PB2, HIGH);  // blue
  delay(200);
}